anybody got a fake .50 cal gun

Watch the last 35 seconds of this video, this could be you! https://m.youtube.com/watch?v=K2xzaUXtL2c

 

Rondog ,,,,,,and then go directly to jail.... I can't play with the gun I have already .........

 

Huh?

 

Don is referring to the Tease and Please in South Lake Tahoe. It was all fun and games till Don poked a hole in one

 

how long is a .30 and a .50 cal round so I know how big to make the opening ? and can I get a short belt of fake bullets ........

 

I didn't notice you're in CA - every cop in the area will be standing in line for their turn to harass you!

 

this will be a trail gun only


"thou shall not exhibit a fake deadly weapon "

 

The 30 cal (7.62x51mm) is 2.810" long and 50 cal (.50 bmg) is 5.450" long. For fake ammo search for dummy belted ammo.

 

A couple of years ago, I built an M2HB for my 1942 MB. It was a ton of fun to make. Angle Grinder & MIG welder is really all that is needed. Instead of using rivets, I center punched the rivet location and MIG-ed up a little bead on that mark. After a lite sanding - flap wheel on grinder) they look just like rivets. The barrel is hard to duplicate. The plans came from the G503 board and should still be there http://g503.com/forums/viewtopic.php?f=30&t=86813. I really built 2 of them. I sold the first one to a re-enactor and used that $$ to buy more "real" parts for 2nd gun (right side charging plate is very difficult to replicate and have it look real). I bought a resin barrel - copper pipe inside resin mold. The gun still weighs over 40 lbs. I also built a dummy 1928-A4.

Go for it and have fun!

49T&C

 

I am going for it ,,,,,,I need a small 12v motor though .....junk yrd time I quess

 

Maybe a stepper motor or one with a gear reduction to slow it down...........

 

????

 

it can only be 3 3/8 wide motor

 

What the.....that doesn't include The Lord's Rounds of .30-06, .45acp, and .30 carbine!

 

heres where Im at
so far bolt slides ,that was easy
my first idea for the motor bolted inside to the front of the box wont really work ......now moved on to a full lenght shaft with bearings on both ends and spun by a offset motor either gear,chain or belt drive
I think I will have to farm out the spinning barrel assembly to someone.......I want it out of alum for weight .my concrete skillz are usless here ......

 

Looks great
Great addition to the builds and fabricator forums