16" Wheel Measurement , Please.

Hey Fellahs..... Can someone post an inside Rivet to Rivet diameter measurement of a K-H , 16" Wheel ?
Here's Hopein'
Thanks,
....Richie

 

Check the first post on the link--it may be of help>>> https://www.thecj2apage.com/forums/wheel-modifications_topic41512.html

 

13" to the rivets but the slots come in smaller at 12 5/8"

 

Thanks Dave & Upstate....... From that , I reckon it's 12 3/4" , Rivet to Rivet

 

Yes Sir.....Wheels arrived today & like you said, 13" rivet to rivet & slots / flange 12 5/8" . Thanks for the heads up. They just touch my front discs. Haven't tried the rear finned drums yet .
Spacer time. Does anybody make a 1/4" to 3/8" wheel spacer?

 

they clear the finned drums and just clear the track kick disc brackets and calipers. i had to tune the edge of the slotted part with a hammer to get the last 1/16 i needed

 

I’ve seen 1/4 spacers at my FLAPS, and they’re available on Amazon as well, but they just float between the hub and wheel and seem a bit sketchy to me.

 

Yeah, Buddy.......Just a bit of pounding & I'm good to go.
I had a good afternoon today . I sold my existing wheels & tires to a New Pal. He runs a Powder coating / Fabrication shop & is gonna Powder Coat my new wheels for FREE. Just have to get the powder & start prepping them by sandblasting & a bit of grinding. Mike also said he's gonna dig out the junk spindle for me. I need that for my spinning Jig ......

 

Hi Boop ,
I was educated by a machinist that many track & race folks use various spacers alot ? . The 1/4" ones are no more than a big washer. That does , however, move the wheel off the hub, & just relying on the Lug studs . The trick here is to use a hub extender too. This way it's a slight, but solid , mechanical connection. I think of sorta like a Door hinge gain / mortise.

 

I use the 1/4" spacers on my jeeps they are nice because you dont need to change the studs and they actually make a huge difference in the turning radius