I can see how that could be possible, however, with the factory engine mounts, the wiring harness being original and the 2 stick transfer case, I...
Ok, I have an update. I have several different options I think. I need some advice on what the easiest and cheapest route to go. I have a T98...
I am not sure what to do. I want to go the cheapeat route because it will only be a play toy and will not see much mud or rocks. I do have some...
I need a transmission to bolt to my v6, would you be willing to ship one of yours to just South of Atlanta, GA?
I have read that if the transmission originally was mated to a 4 cyl, then it was the short input shaft, but the 6 was a longer input shaft. Did...
If you could see some of the work that has been done to this jeep you would understand how it was done. I will mainly be using this jeep as a...
I am ready, I want it to be right, look right and run right. Can you lead me in the right direction on where to find a, preferably used, adapter...
Here is a pic of what I am talking about. http://i1297.photobucket.com/albums/ag38/WAaronWood/2013-02-13163455_zps3eb399c9.jpg
That must be the problem. I need one to put it back together right. Do you know where I can find one or how I would go about describing what...
There is not. The bellhousing is bolted directly to the trans. I assumed that there needed to be an adapter there but I do not have one.
I can move the crossmember that is not that big of an issue, however, my clutch rod is in a bind because the transmission is too far forward and...
I am sure the transmission is not original but I cannot find anyone else who has had this problem. I have taken pictures of it but cannot upload...
I am new to Jeeps, especially CJ5s. I just bought a 1969 cj5 with the dauntless v6. It is mated to a t90 trans. My transmission floor cover...
Separate names with a comma.