Well I've replaced the seal once, still leaked. Took it to a shop that has done good work for me before and they replaced it, not once but 2x and...
ok....i'll snip them off tomorrow at 1/4 inch and go from there.
I replaced mine by only removing the rear bearing cap, did not have to loosen anything else on my F134. Get the seal referenced in this string...
how long should the replacement dowels hang down form the bottom? I have them inserted as far as they will go and they are hanging down about 3/8...
Got the rear bearing cap off with lots of wiggling. Had the old rope seal. Problem is it sheared off flush with the upper half of the bearing...
Pictures worth a thousand words!
Thanks, makes sense
When you say you offset them about 3/8 inch....can u explain that?
what are the 2 dowel pins that come with the seal kit (2 halves) used for?
besides removing the rear bearing cap did you have to loosen the rest of the crank bearing bolts? the Kaiser willys parts site says yes, but none...
That makes sense! Thanks
anyone know why the oil pan has a separation or baffle which divides it up about 2/3-1/3? I should have taken a picture when I had it off but...
Bolts. You're right though. Put it back on this afternoon and 12 felt right. Anymore and it felt like over tightening.
Yeah that's gotta be right. I put it back on this afternoon and the 12 felt right. Well know tomorrow when I refill the oil and start her back up!
Do you remember what the torque for the oil pan nuts was? My manual says 39 ft lbs...way different than the 12 above?
Separate names with a comma.