Front brakes, port closest to firewall
Ok, finally back at the jeep, removed the sump and took some measurements of the pickup. Forgive my measurement units but I didn't want to try and...
Sorry, that is mis leading it was not at operating temp, so somewhere between cold and warm I shut it down before it got to full temp as I could...
Ok guys, finally got back to the truck yesterday, I've rebuilt the pump, it was definitely in need of a freshen up and is now all back together,...
I've always used Tractol paints for mine, it's a heavy duty plant/machinery paint that's very tough. So tough you can hit it with a hammer and it...
Yeah, it turned out I got a faulty gasket set where both gaskets were cut identical and as it was in a packet I didn't realise till I went to use...
Nope tried and tested mechanical gauge. Never trusted the electric ones
Went back to the garage this morning to experiment whether additional oil would make a difference (ie if it got above the crack point) however,...
Thanks guys, looks like no choice but to drop the pan again. Any tips for removing the pickup and strainer pipe and resetting it to the correct...
Possibly but the strainer is say 5/8 or so thick. That would say less than 2 quarts in the pan at throttle, I still cant believe that there would...
I dont believe there is any gaskets on the intake, it's one piece and screws directly into the block
Possibly but I believe the gap between the strainer and pan is around 5/16 or so, that would mean less than a quart of oil in the pan which I...
Guys, I've still got problems, below is the full story. What do you think Guys, I need some advice, a couple if weekends ago I was out wheeling...
Guys I'm having to replace the oil pan gasket on my AMC 360, I brought one but it's not the right part as it doesn't fit. my sump has a bulge at...
Separate names with a comma.
