1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice
Jeeper Creeper
Last Activity:
Oct 20, 2010
Joined:
Oct 21, 2003
Messages:
73
Likes Received:
0
Trophy Points:
6

Followers 1

  1. Doug
Location:
Markleeville CA
Occupation:
Retired

Share This Page

Jeeper Creeper

Member, from Markleeville CA

Jeeper Creeper was last seen:
Oct 20, 2010
    1. Warloch
      Warloch
      I got about 3"s lift on the Holbrooks. I really don't like SOA and have several buddies that run 7s and 8s that have gone back from SOA to SU due to the tippness they were getting (and that was with full width axles). They also like how I can go almost any where they can (except full ledges) with smaller tires etc.

      I'd be careful with the YJ springs - I have been thinking of doing them as well, but think I will go with Holbrooks or measure out mine and see if Alcan can build a set to compare with. Everyone I have seen with the YJ setup has to extend the front and rear frame rails to allow mounts and keep the axle in the right place.
      Mar 24, 2009
  • Loading...
  • Loading...

  • About

    Location:
    Markleeville CA
    Occupation:
    Retired

    Interact

    Content:

    Signature

    1974 CJ-5
    258 Engine with MC2100 Carburator (2bbl)
    Holbrook Specialties LongLeafs
    T-18 Trans (4 speed) w/6:1 first gear
    37" TSL's, ARB Lockers in the rear
New Posts