How skinny? Interco sells some 15's that are 9.5" or skinnier.
I finally found the time to work on this again. I ended up using a dremel with a small cutoff wheel and cut through the inner race almost all the...
I watched the metalshaper one. Unfortunately (fortunately for him) the bearing in question is just loose on the shaft in his somehow, so he...
From Novak's site: Drive a large screwdriver or similar shaped tool between the front bearing and the output gear to separate the gear enough to...
Hello all, I am currently taking apart a Dana 18 with the larger 1 1/4" intermediate shaft to build a combo D18/D20 for my '74 CJ5. I am asking...
I don't have a picture but I put them at the top of the windshield on my '74 CJ5. There were two holes on each side of the windshield frame. I...
I just bought a 1973 John Deere 110 with additional snow blower front attachment. My grandpa was into John Deere's and had a huge collection of...
#12 on this page? 1955-1986 Jeep CJ5, CJ7, CJ8 Scrambler Parts|Jeep Exhaust Parts|Morris 4x4 Center
Carandcoffee by scuter83 posted Mar 6, 2018 at 1:05 PM One of the other toys. 1988 Mazda RX7 with basically a cam'd LS3/T56.
Jeep Speedometer Gear Tooth Chart
Jeep CJ5, CJ7, CJ8 | A/C & Heating Parts | Morris 4x4 Center
So the primary lead wire going into the distributor had..uh....let's just say a less than favorable electrical connection. Red-did that and it...
Separate names with a comma.
