I bought one for my build but am not yet ready to rebuild the engine. so I too would like to know before putting it on or reverting to the...
Possibly not a ‘53 as it has a center mount grill vs hinges? Dennis wish mine had been this good looking!
Rear swing axle and reputed roll over prone. wasn't this blacklisted by Nader ? Really wanted one when I was in high school, yard had a few of...
A two groove crank pulley and a two groove water pump pulley please Thanks Dennis
Expensive but it has a high yoke, might work with a Dana 20? Hi-9 in a Ford 9” housing Would be very very short driveshaft though. Dennis
I used a dimple die on my boxed sections approximately every 12-14 inches. Stitch welded the additions, from the frame horns to the rear including...
PM sent
These are what I bought for my M38A1 http://www.canvasco.com/ Post war jeeps tab
Thanks for the offer, got one yesterday in the mail from another member. Sorry should have made a note in the wtb Dennis
No problem, thanks for looking
I have a couple of possible things for trade: 3 groove pulley Or a set of the AA aluminum windshield hold down clamps Or?
Separate names with a comma.