No, there is a polyurethane mount that supports the transmission and the transfer case as it sits on the tube. The adapter between the automatic...
None whatsoever! The motor mounts are rubber, the transfer case mount is polyurethane and the crossmember bushings are polyurethane. It’s a solid...
Thank you. The first picture I posted is after I took entire system off the have the wrap around pipes ceramic coated. I should have built it with...
Wrap around for my Chevy V6. [ATTACH]
Both are 3/16 plate steel.
Exactly correct! It’s really nice to be able to quickly drop the skip plate with 4 bolts and still have the drivetrain supported by the cross...
Drivers side photo. The tube crossmember is not perpendicular with the frame rails. It’s more rearward on the drivers side so the transmission...
.[ATTACH][ATTACH][ATTACH] Barnes kit.
This is the one I have for my 1976 CJ with a Chevy engine, I don’t know if it’s compatible with your 1971. Northern Radiator | Muscle Car...
I made a tube cross member then a separate skid plate out of 3/16 plate steel. The components for the cross member were obtained from Barnes 4X4....
A Chevy truck, Blazer, ect, with a 700r4 would have driver side drop transfer case.
A 700r4 can be use without a computer. It does require special throttle linkage and a different servo inside the tranny if I remember correctly....
I put an additional fill plug on the back of my 9 inch housing about two thirds up on the ring gear hump. The new plug and bung only protruded out...
I have personal experience on the terrible quality of aftermarket fenders. I ordered and returned 3 pair of Omix and Crown fenders because of...
That’s a very nice modification, I regret not shaving mine. Will you be adding an additional fill plug other that the one on the third member?
Separate names with a comma.