I wish I made one. I flipped mine by hand end on end when I did my tub. It got old real quick. I'm not sure where you plan on getting your floor...
Your actually lucky. Most of those that enter the coolant passage break off and seems like tool steel when you try to drill them. I have one like...
This is exactly what I did. I bent the hardline and it exits through the existing hole between seats to the rear (return line). I then ran it...
This brings back nightmares. For a couple years I fought with overheating just as you describe. My solution was to move the trans cooler that sat...
I have one and don't pay much attention and my focus is usually on coolant temp. On the other hand, I have an auto tranny and I pay close...
I have a trail jeep and a parade jeep. My parade jeep is ok for light trails but I don't bother taking it out much these days. As I got more into...
That's funny. F-IT, not worth the effort. In my oil shop days, I remember one time, we kept trying to fill this car with oil and it would just...
Geez. When my wife said her dad made her run parts, change oil and watch him rebuild her engine after she put a hole in her oil pan, I was able...
On the topic of re-power, I'd keep it stock. It's classic and looks like a very nice M38, all original. For an around-town classic car that's all...
I added one. Got so sick of pulling the drain plug, messes and having to reseal. I tee off and the 90 deg outlet on fitting is the hardline to...
Not a machinist but they probably cut the pocket for the seat and that brought it very close to the water jacket. Probably close enough that it...
I firmly believe in having an expert inspect and measure before I rebuild any engine. Many of us can put it back together and save some money but...
Electrical probably. All the stuff duffer said. Also note, the solenoid can stick so listen for a click at the starter or wherever it's located....
Not sure what carb you have but an accelerator pump in carb can do that and it's easy to check. Throttle it by hand from under the hood and if...
That's a good approach. Ease into it and see how it holds up. I welded on a permanent tow bar for this exact reason. I live close to the desert...
Separate names with a comma.