hope the crank sensor is coming along
hey jw i was looking a some of your old pictures. my heater hoses are connected to the right rear of the intake manifold, and the the port on the...
I was explaning to jw about the coolant sensor. to me it is about the most important part of that tbi system. I was supposed to try to find a...
this is something you might like. i have a hardtop and had the same mirrors, but didn't like that the door would hit them and they stuck out a...
i think the formula is if it is backfiring out of the carb it is firing too soon . needs to be retarted. make it fire later. if it backfires out...
hi me again, that coolant sensor must be in the hose going to the heater yes. you probably see after using this kit for a while that when you...
oh geeze me again, i was looking at one of you pictures, the hose that your coolant sensor is in, it disappears into the fire wall. is it a heater...
did the kit come with the crank sensor and coolant temperature sensor, map sensor too.. might not be too hard to hang the crank sensor. maybey...
this kit must have a coolant temp sensor. that i think runs the engine when it starts and is cold. as the engine warms up the o2 sensors take...
get some measurement so you can redrill in the same place. get a mig welder and fill it with cast iron wire. cast usually drills pretty good.
with the picture at the top, of the tbi, i swear it looks like the throttle body off of a 4.3 chevy engine
the bearing should still pull ok. might be a little harder if you burred up the bottom. if it goes too hard you could weaken the bearing by...
how far down in this hole is the broken piece. carbide bits are usually pretty short so are burrs. they make some drill tools that cut and extract...
again very very nice. good choice on the box
you will need a piece of 1/2 in or 3/8 threaded rod. a couple of nuts. we will build a cheap sliding hammer.the washer might be a 7/8 or...
Separate names with a comma.