Ford T18 Trans Mount ......napa Part #?

well the mount I used when I did the swap from Muncie car 4spd to ford t18 has bit the dust after 10+ years .... thinking rubber is better than than the poly mounts of today ,,, the rubber will isolate vibration better and allow a little more movement ...... what do you guys think? ,,, I have Napa motor mounts on my V6 and those are also showing signs of tearing ..... I think those are lifetime mounts and I still have the paperwork ,so those might be next ... the ford t18 has mounting holes 3" apart and 1 1/2" at the custom cross member . anybody have a napa part number for this ford mount ?

 

What you are describing sounds like the mount I have. I don't have a part number but try looking up a trans mount for an intermediate with the T-18. That should bolt to the mounting holes in the adapter plate. I know I just used the stock mount when I did the swap.

 

Never mind.....mine is a 2 hole, looks like Napa part number BK 6201241.

 

I think 6201101 might be what you need.

 

I will check it out thanks sir !

 

Nope either one doesn't work ......if you have a ford t18 is the mount the same as a jeep t18..... what yr jeep had the t18 ...?

 

would a jeep T18 mount work . mount is on transfer case adapter

this is one on spare transmission

 

went out and looked at jeep . doesn't look like the one above .
have two one on spare trans and another one in parts box , from when I did swap . maybe T14 mount

just don't remember . does look like this one
Crown Automotive J1370910 Transmission Mount for 83-86 Jeep® CJ Series with 2.5L 4 Cylinder Engine, 72-86 CJ Series & 72-90 SJ & J Series with 4.2L 258c.i. 6 Cylinder Engine

 

yes very close Twin 2 .....thankyou ...just need to check the hole spacing