Shut The Front Door

Wierd!
No not filler, they are 2 small u brackets, almost what a door restraint would attach to

the channel maybe still useful as it is to hold a seal

thx all, Wierd customization to be sure

 

your missing windshield filler pieces . left and right for door seal
I didn't notice door brackets were on wrong side (door) till glenn pointed it out
and I still say the solution is move hinge up on door . after you switch sides

 

How do filler pieces attach?
Maybe this was all a workaround for that?

I find it wierd that hinges were not mounted to doors from myers/Orville etc. I guess they came as a kit

 

filler is bolted with windshield hinge + door hinge (upper)
still another piece for meyers door . fuel indent piece . covers opening at rear of door


last one

 

OK, looks like it is going to be reworked as opposed to fabricating a new bracket. I think the lower brackets are actually installed upside down also, note the door gap

Frankly at this point I wouldn’t be surprised if the passenger door mounted better on the driver side and the driver side or passenger LOL

Twin can you post a picture of the lower door hinge. I’m looking to see if mine is just bent or it’s clearly upside down. Either top view or side view would be helpful so I can see where the pieces fold it over. It’s hard to believe that this wrong also. Maybe this was actually the start of the problems with this lower hinge being on the wrong side thus setting up the catastrophe of errors

 

Better, Swapped the lowers first
No gap

 

Heres a little drawing of the window channel if you are up to making them. It just gives you a place to put a foam seal.

 

Thank you!

hinges were a fight(still fighting w passenger) as they were bent to fit when installed wrong.
Will fight a bit more tomorrow, thx for help all

 

Driver is smooth and easily slides on/off
Passenger is still a fight,

 

I have doors like this and hinges. When in position the doors open and close well. nice if you drive in cold weather.
Doors come from above and insert in the hinges.
Because all this is very heavy to manage alone I don't put top and doors since 3 years.
I just want to confirm that with patience and help all fit exactly well, no mystery.