I have an offenhauser 360 dual port like this one I'd sell....
Dan if the t-18 is out of a 75, your closer than think. Tmgr is right, for $100 its worth getting. The adapter on the back and the out put...
Hey Dan, you at Fort Bliss? My daughter is a medic there. I have lots of experience with t-18s. The Jeep one unless its out of a cj (and that...
I've already tried this once....nadda! The output shaft on the t-98 fits only 2wd yokes. You will need to get the correct output shaft like Lynn...
oops....thats 6 bolts for t-14 and 8 for t-15
if you want to know what tranny you have....crawl under it and count the shift tower bolts. T14 will have 6 and the T15 will have 8.
NIce! Your steering conversion will go fine, you will need the coupler though and you can change yours on the end with the p/s one from the 78...
If the drivetrain is stock than the 4 spd is a t-18 coupled to a d/20 and the rear end is a centered dana 44. This is a good jeep. It most...
Lavaman, Gets a little confusing huh? I say its a good idea to go to the T18, depending on the route you take here is what you'll need Stock...
I believe you also would need the correct flywheel or yours balanced to the even fire engine, as I believe yours to be odd fire.
I believe the V8's also used a brace across the frame under the motor mounts. I am not sure if any I6's had this. Ed
I wanted to sell the whole set....4 drums 4 backing plates loaded with used hardware. $100
mine either
Not normally, I think its done that way for ease of shifting between all three positions. LIke Tim said, just don't do it at high speeds...not too...
I have a full set of used of interested. Let me know JeepManEd@msn.com
Separate names with a comma.