OldPappy are saying not to use the air hammer due to messing something up? When I used it, just a couple of bursts made it pop loose, no hard...
When I rebuilt my tapered axles, I was successful in removing the first hub with an air hammer on the shaft indent, but it didn't work on other...
I used blue on metric bolts to caliper bracket. Red on the 6 stud upgrades.
I used a 78 Corolla MC with a remote reservoir kit. I also used standard tracker calipers and rotors. Here's what I copied....
If you have KH 15" wheels, you will most likely have to space them out, or grind on the caliper a bit. I chose to grind caliper. I also did the...
I think I was messing up the calipers by running them all the way back each time. Theres a lot of very small ball bearings and springs inside...
I pulled the spring, washer and rubber washer off of my brake pedal shaft and all seems good now. Drove it around, braking a lot, and nothing got...
If my pushrod was a little long, and wasn't letting plunger all the way out at rest, would that cause my pedal to get increasingly hard and...
Question, I got my new calipers installed, bled brakes, had a soft pedal, bled some more, found more air, got a good pedal. Went for a drive,...
I figured it out. The company i bought the calipers from function tested the motors, and I think they ran the pistons out too far. There are a...
It looks like the stud on the back pad that rides in the slot on caliper center sheered off. Not sure if that would cause this , but I'm pretty...
I dont have the brake system bled yet. I did install a Toyota corolla master, which as far as I can tell has no valves in it. I did install 2 lb...
I'll take another look and make sure its still centered. Doesn't the caliper somewhat float on the pins? JT
I wired up 4 relays to switch + and - to motors. I can tell the motor sets the brake by seeing the pads tighten, then when I switch it to (off),...
How tight should these calipers sit at rest? I can apply 12v to lock caliper down, and then 12v to release it, but it still seems like its tight....
Separate names with a comma.