1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

What To Expect When Installing Koenig Pto

Discussion in 'Winches' started by mickeykelley, Oct 2, 2018.

  1. mickeykelley

    mickeykelley Well-Known Member

    Getting ready to install the Koenig PTO I bought and am trying to understand a few things before I start. When I remove the cover on the transfer case, should I be expecting lots of oil to come out, like when pulling a differential cover! I am aware of being careful not to drop one of the hex bolts or washers. I was thinking of using a little grease in the head to keep it on the driver. After installing it, do I add fluid to the transfer case or where?
     
    Last edited: Oct 3, 2018
    mickeykelley, Oct 2, 2018
    #1
  2. Howard Eisenhauer

    Howard Eisenhauer Administrator Staff Member

    Should not be much if any oil coming out, the fill level is below the opening.

    You'll only need to add oil to the PTO, little if any migration between the PTO & transfer case.
     
    Howard Eisenhauer, Oct 3, 2018
    #2
  3. Steve's 70-5

    Steve's 70-5 Active Member

    I used allen head bolts. Check literature before using hex
     
    Steve's 70-5, Oct 3, 2018
    #3
  4. mickeykelley

    mickeykelley Well-Known Member

    Oops. Meant Allen. That's why the little bit of grease to hold the 'allen' onto the 'hex' bit.
     
    mickeykelley, Oct 3, 2018
    #4