1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

27 Spline Dana 30 Front Warn Locking Hub Needle Bearings

Discussion in 'Intermediate CJ-5/6/7/8' started by Allan, Apr 13, 2020.

  1. Allan

    Allan 74 Renegade

    Does anyone know where to find the needle bearing that’s pressed in the back of the warn hubs, they made a needle bearing back in the day, then they switched to a graphite looking solid rubber type? Pic attatched
     

    Attached Files:

    Allan, Apr 13, 2020
    #1
  2. wally

    wally SSSSTER

    nothing wrong with the "graphite looking solid rubber type". i've put over 100K miles on the pair on my '75.
     
    wally, Apr 13, 2020
    #2
  3. jeeper50

    jeeper50 jeeps 'till I die

    Last edited: Apr 13, 2020
    jeeper50, Apr 13, 2020
    #3
  4. wally

    wally SSSSTER

    no, those are the seals and spindle bearings. the OP is looking for the bearing inside the warn locking hub.
     
    wally, Apr 13, 2020
    #4
  5. jeeper50

    jeeper50 jeeps 'till I die

    OOPs my bad!
     
    jeeper50, Apr 13, 2020
    #5
  6. georgecj6

    georgecj6 Member

    I need to replace mine too.

    The number on the bearing is Torrington Y246. I was researching and found that Timken bought Torrington. Then someone said that the number changed to B246. Someone else stated the bearing is obsolete. I did not have time to check Motion Industries to see if they have the bearing.
     
    georgecj6, Apr 13, 2020
    #6
    Allan likes this.
  7. todd hofsaess

    todd hofsaess Member 2022 Sponsor

    I was missing a couple of the needles from my hubs and could not find a Y246. I went on Mcmaster Carr and used some PEEK 1/8x1/4 dowel pins for the missing ones. Fit right in. No report yet on longevity.
     
    todd hofsaess, Apr 13, 2020
    #7
    Allan likes this.
  8. Allan

    Allan 74 Renegade

    Seems like such a waste, I can’t find a fiber bearing for one side, Shame on Warn for not making them available or in the rebuild kits
     
    Allan, Apr 22, 2020
    #8