1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Dauntless 225 V6 Timing Cover Front Seal Update

Discussion in 'Early CJ5 and CJ6 Tech' started by Bulldog Shoaf, Sep 29, 2021.

  1. Bulldog Shoaf

    Bulldog Shoaf Member

    Was looking through the forum and read about updating the old timing cover crankshaft output seal with a FELPRO 15200, but no clear guidance or direction on the subject. Well, I figured Columbus took a chance so I went ahead and took a run at it. Photos below show the process, but it comes down to using a 1/2" open end wrench to "pry" out the old one, clean up the three press indentations with a Dremel and pressing in the new seal. Very easy, even for a knuckle head like me, slicker than socks on a rabbit.


    upload_2021-9-29_16-25-47.png
     
    Last edited: Sep 29, 2021
    Bulldog Shoaf, Sep 29, 2021
    #1
    Walt Couch likes this.
  2. Walt Couch

    Walt Couch sidehill Cordele, Ga. 2024 Sponsor 2023 Sponsor 2022 Sponsor

    Welcome aboard Bulldog Shoaf.
     
    Walt Couch, Sep 29, 2021
    #2
  3. Jeepenstein

    Jeepenstein Me like Jeep.. 2024 Sponsor

    Nice, it's a mod I plan on doing when I get to that point.. someday.. maybe..
     
    Jeepenstein, Sep 30, 2021
    #3
  4. Ollie2009

    Ollie2009 Member

    Thanks. I just bought the seal and am going to install it.
     
    Ollie2009, Jul 12, 2022
    #4