Bellhousing Bolt Pattern Measurements

Hi all. A long time ago I was able to find a picture with the t90 bellhousing, with the measurements for the bolt hole locations. Does anyone have a document with them on there, or anyone have a similar picture? I’m making an adapter and need it. This is a picture of the picture I took for social media, and as you can see it is covered slightly. Any help would be greatly appreciated. Thank you.

 

welcome, new facebook recruit. i can get the measurements, i just need to know what measurements.

 

I will have to check that out. Thank you

 

A little confusing but i need the measurements off the X and Y axis. so if the shaft is at center, then say X is east and west, Y would be North and South. I need the orientation measurements off of center. That way I can use a Bridgeport to drill the holes in the adapter. I have the TDI "CAD" drawing but need the t90 bell. its confusing.

 

i thought i saw somewhere it was a bop #5 bell. maybe not, after a quick google search.

 

Found it!!

 

Good find!