hanging pedal conversion on a DJ3A

I'm swapping a later model drive train in my recently aquired '56 DJ3A. I'd like to switch it to a hanging pedal set up for a hydrolic clutch. Any write ups on this? I've been searching and haven't found anything yet.

Thanks!

 

I just ran across Advance Adapters clutch chain. Looks like an easier route to do. Any comments on it?

 

i have a set of swinging pedals from a cj5 that i am looking to sell if you are interested.

 

Do you still have the swinging pedals for sale?

 

yes, i will dig them out and take a picture.

 

OK email me them I would like to take a look, thanks.

 

could not figure how to upload pictures to email message. here they are.

 

I am also interested in a set of swinging pedals for my Frankenjeep.

 

I've had success finding TJ pedals here in the junkyards. They work well, and are a bolt-on for use with GM steering columns. I used a nice one from a '84 Firebird. I did have to cut, and shorten both pedal arms to fit my clearances about 1-1/2". I got a power steering pump from a Blazer.
Saginaw box out of some mid 70's yank tank.

Rob
_________
'47 CJ2a gonna build this summer W/ 225 V6
'52 & '53 M38A1 parts
'58 & '67 CJ5 parts
'54 CJ3b F134 ALMOST ready to rummble
'67 CJ5 Tux, parts
'78 CJ5 360, go-go sca