1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Bulltear Distributor Gear

Discussion in 'Intermediate CJ-5/6/7/8' started by ether7, Mar 2, 2008.

  1. Mar 2, 2008
    ether7

    ether7 CJ8 and CJ5

    Edmonds, Wa
    Joined:
    Oct 5, 2007
    Messages:
    21
    I purchased a matched set of cam/distributor gears from Bulltear. The distributor gear does not have the retaining pin hole drilled all of the way thru?! If I put the gear on, the pin will not sit flush with the shaft surface because there is no hole on the other side of the gear collar. Im concerned that I wont be able to remove the gear because I cant punch it all of the way thru. Anyone seen this tye of gear?

    Thanks
     
    Last edited: Mar 2, 2008
  2. Mar 3, 2008
    fuzz401

    fuzz401 New Member

    lancaster pa
    Joined:
    Oct 18, 2005
    Messages:
    30
    call bulltear and tell him this
     
  3. Mar 4, 2008
    ether7

    ether7 CJ8 and CJ5

    Edmonds, Wa
    Joined:
    Oct 5, 2007
    Messages:
    21
    I did call Bulltear. I always get voice mail. Their products are great but they take a few days to resopnd to phone messages or email. Not sure but it seems like Bulltear is one guy working evenings!
     
    Last edited: Mar 4, 2008
  4. Mar 11, 2008
    ether7

    ether7 CJ8 and CJ5

    Edmonds, Wa
    Joined:
    Oct 5, 2007
    Messages:
    21
    Just for the record the gear is intended for an MSD distributor. I had to dill the gear through and use the roll pin. Pain in the butt!
     
New Posts