1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

Right angle speedo gear drive

Discussion in 'Early CJ5 and CJ6 Tech' started by grannyscj, Mar 30, 2008.

  1. grannyscj

    grannyscj Headed to the Yukon

    Bought one a couple of weeks ago. Meanwhile I had been following the thread about other's speedo problems. The input shaft was very long on this thing so I took it out and inserted it in the speedo port on the TC and slowly pushed the jeep forward to see if it would catch on anything. It did, so I backed it out until it stopped (about 3/4" inserted). I cut it back to where only about a half inch would insert into the port.

    The new routing of the speedo cable has no sharp bends and routes up the tranny tunnel and straight into the speedo using the old choke cable hole (I don't use a choke anymore). The grease zert allows lubing the cable and everything runs nice and smooth now. I'm quite happy. Here's some pics.
    View attachment 21912

    View attachment 21913

    View attachment 21914
     
    Last edited: Apr 13, 2008
    grannyscj, Mar 30, 2008
    #1
  2. tinker

    tinker GNGPN

    where did you get it?
     
    tinker, Mar 30, 2008
    #2
  3. grannyscj

    grannyscj Headed to the Yukon

    grannyscj, Mar 30, 2008
    #3
  4. Eric B.

    Eric B. Confused???

    Said screw it, ordered one of the right angle adapters, printed the directions found in history on how to take apart and clean/rebuild speedo cluster. Now I have a dinner table project for next weekend, with the speedo. Do the cable part at work on a alignment lift with stationary testing ability.
     
    Eric B., Mar 30, 2008
    #4
  5. Warloch

    Warloch Did you say Flattie??? Staff Member

    Rocky - how far does that stick out? I put my new Xmember for the SM465 in the wrong spot and now can not get the electric sender installed or I have to move the new mount.
     
    Warloch, Mar 30, 2008
    #5
  6. grannyscj

    grannyscj Headed to the Yukon

    Maybe 2". It doesn't clear the side of the TC, but it does provide enough of an angle to get a much smoother bend. The input shaft is way long, I cut off ~3/4".:v6:
     
    grannyscj, Mar 31, 2008
    #6
  7. Eric B.

    Eric B. Confused???

    Thanks, for the input. I'll know more when I get it here and get it installed if you wanna get a look at it Chuck.
     
    Eric B., Mar 31, 2008
    #7
  8. Warloch

    Warloch Did you say Flattie??? Staff Member

    Thanks - Let me know when you get it Eric, I would rather do that than reposition the tranny/tcase mount to get my spedo hooked up.
     
    Warloch, Mar 31, 2008
    #8