1. Registration trouble? Please use the "Contact Us" link at the bottom right corner of the page and your issue will be resolved.
    Dismiss Notice

PO steering shaft design holding up my Dana 30 install

Discussion in 'Builds and Fabricators Forum' started by dnb71R2, May 22, 2010.

  1. May 22, 2010
    dnb71R2

    dnb71R2 SuperDave 2023 Sponsor

    Grand Mesa, CO
    Joined:
    Aug 13, 2006
    Messages:
    1,320
    deleted
     
    Last edited: Jun 23, 2012
  2. May 22, 2010
    Joe 69cj5

    Joe 69cj5 Going into Retirement

    Llano Ca.
    Joined:
    Aug 14, 2008
    Messages:
    152
  3. May 22, 2010
    Mcruff

    Mcruff Earlycj5 Machinist

    Albertville, AL
    Joined:
    Sep 22, 2002
    Messages:
    5,349
    With Borgeson, call them and tell them what you want. All of there ends are available to fit, in otherewords they can and will mix and match to make exactly what you want. If you want a 1" diameter smooth bore on one end and 13/16"-36 spline on there other they will put it together for you.
     
  4. May 22, 2010
    neptco19

    neptco19 That guy....

    Athens, GA
    Joined:
    Sep 26, 2003
    Messages:
    1,381
    Check out speedway motors, they have tons of those steering joints and are much cheaper than most places.
     
  5. May 24, 2010
    dnb71R2

    dnb71R2 SuperDave 2023 Sponsor

    Grand Mesa, CO
    Joined:
    Aug 13, 2006
    Messages:
    1,320
    deleted
     
    Last edited: Jun 23, 2012
New Posts