That's beautiful by east coast standards. I'd like it south of $3k.
Facebook Marketplace: AMC Jeep T-15 - Auto Parts - Rossville, Maryland
In the state
Roll bars and chosen levels of protection are a timeless discussion.
One thing I don't see a lot of discussion on is restraint. I've been...
Bookmarked under " ideas to shamelessly rip off"
Facebook Marketplace: Old military jeep cj winch/pto - Car Engines & Engine Parts - Cicero, New York
Non Saginaw PS Solution
99-04 Grand Cherokee pretty fast box. I have a small body lift so the shaft slips under.
Guys this engines a good runner, seen it myself in person. I can tell you sending a v6 through the machine shop is easily $2-3500 depending on how...
Pedal ratio problem? Reread your thread. There may be an issue with Novak's master and your pedsl assembly setup.
Your right at 2:1. 1" of travel at the slave won't get it. Assuming everything correct you need a little better than a half inch with a GM clutch....
How far from the pivot ball to the slave attachment?
At least someone has broken them in.
Facebook Marketplace: lift - Auto Parts - Kabletown, West Virginia
Anything's possible. You'll have to ascertain the bore and stroke of the master and cross reference to an appropriate slave. Then there's the...
The dash is fiberglass and my braces are out board. It's a thought, not sure about the benefit for my construction.
[ATTACH] [ATTACH] [ATTACH]
I just looked again and realized that driver's manifold is not rear dump. That's grossly over priced.
Up for discussion. The existing cage turned out to be hrew. More or less 1-7/8 od. Tubing I had bent is 1.5" Dom 120wall. Had some 1-7/8 Dom...
That's reasonable for those manifolds
From a cj, can't say if Intermediate or late
It has a date at Peake Fabrication in Stevensville MD tomorrow. Cage, seats, harnesses.
Separate names with a comma.