Ok what are some cheap ways to make a long travel (front) driveshaft? I can’t afford to shell out $250 or more at the moment.
I found a drawing online of an 8274 but I want to confirm. Is the front to back (depth?) 8.5"? I need to make sure I leave room for a winch; more...
Are these what I think they are?
So anyone have experience with any of the $200-400 units? I was looking at some with pilot arc.
Just the housing and axle shafts left
Pickup at 39056
Pickup at 39056
I have 3 D25 units. Two are 5.38 ratio one unknown.
1 D44 tapered ratio unknown
$20 for all three D25
$6 for the D44
I consider these cores. I...
Most of my pictures disappeared so let me try this again. :susp:
I traded a set of tires for this 55 3B on July 23, 2018. I wanted to make it...
I’d like to hear from the folks that have run YJ springs soa or sua, CJ5 springs vs the stock leaf springs. I’d also like to hear about...
It still works was stored inside. Older Harbor Fraught model. I need to make a table for it to roll around on.
Picked this up today. Only cost me gas. Came with a helmet and box of electrodes.
A Cone WO-51575-V CONE, tapered, roller bearing, No. TlM-14131 (Includes rollers and cage, type TS, SR, 1.3125 bore, 0.771 width) (output shaft...
Been wanting another Jeep so I found this one. The slave cylinder quick connect was leaking so I fixed it in the guys yard and drove it home....
'81 CJ5 Renegade
Well I got this Jeep to keep me busy this summer among other things and here is my repair of it.
Cut out some carpet,...
Separate names with a comma.