It looks to be about $50 usd due to being international.
Sold.
Based on this 4cyl distributer it looks like the used the same cap molding but left every other terminal off. It might be worth either calling...
Nah just trying to get rid of stuff I've accumulated over the years. That said if you're looking for something L134 specific I might have it....
[IMG] Generator from a running L134 engine. Spins freely and clean oil came out of the lubrication ports. I have not tested to see if it works....
So...uhh...what exactly did you do to make the pontiac distributer work? Thanks.
Located in Canton, GA. $100 Shipped in lower 48. OBO [IMG] [IMG] [IMG] [IMG]
Come on over.
What measurements do you need?
Unfortunately the trip to Moab has been cancelled due to a positive covid case in our family.
I recently put a set of NOS M38 rear springs on the front of my 3A using the factory rear mounts and custom shackle hangers which stick out a bit....
Does anyone know the proper part numbers for the aforementioned swap? In addition to the dutchman shafts of course.
You're not saving much out of pocket but you're extending the life of a tire carcass before it ends up in a landfill and reducing the amount of...
I have not but I'm considering it.
If @Scott Sherraden passes I can definitely drop it off outside St Louis.
Yea as of right now we'll be driving I-70 across Kansas. If you want to meet me along the route let me know.
Located in Canton, GA but I'm driving to Moab, Utah in November and I can drop it off at my brothers place in Denver, Co. $75 OBO [img]
I'm of the opinion that garages/shops are like gold fish tanks. You will always expand to fill them.
Yea it’s absurd. He would have built bigger but our county requires drawings stamped by a licensed structural engineer for anything over 2000sqft....
Ok, I assumed he was talking about the industrial roll-up due to the size of the opening. A friend of mine is building a 1900sqft 4 bay garage...
Separate names with a comma.