I would also comment - the ammeter circuit also provides power to the dash and lights. There will be a splice under the dash that branches to...
Have you read the circuit diagram, Sec 3 fig 10? Anything that's given the ground symbol is connected together. I would check if #3 is connected...
Possible you did something wrong. The main drive gear (MDG, input) is connected to the cluster gear, and both turn constantly with the engine....
Looks the same to me. [ATTACH] This is from the '72 TSM. The TSM also has helpful diagrams of both the circuit (in section 3) and of the harness...
Where's the original? Do you have an ammeter?
NP - they're just wrong. Likely it was a fleet color in some other year and has the same code. Here's the PPG sheet for '73 Jeep - says the same...
Neat. (y) Showing driving in the surf is irresponsible on Jeep's part, I think. Where I worked, they sold quite a few Jeeps to the beach cities...
Sporty but tough! (y)
There's another possibility - the agency needed the Jeep now. May is very late in the model year (note the high sequential number - 700,000...
Hi - I don't know that there's any compulsory tracking of vehicles by VIN other than what the states do for licensing and registration. I had...
Dorman - any parts store can get these, typically next day: Dorman Products - Search Results
Indeed, this looks pretty slick. I did not realize the clutch pedal is on the outside of the frame rail, where there is plenty of room.
I don't have a book that covers the 1972 CJ. However, that won't stop me! :coffee: If it were for me, and I was keeping the cable, I'd look for...
Yep, not as tall as 3.73. 5.38 * 0.75 = 4.04 ish. Still taller than the optional 4.27 gears jeep offered with the F134. 30% overdrive sounds like...
Passenger drop? Short adapter? The pickup truck adapters I have seen are long, like 10-12". Recall what I wrote that there is lots of history of...
You mean a Jeep 3-speed? You'll need an adapter to the SBC. If you use some other 3-speed, you'll need an adapter to the Dana 20. Assuming such an...
'72-75. They come with good brakes and all have decent axle ratios too. 3.73 standard, 4.27 optional. Those would be good, but why are the brakes...
Well, it was a step down from the Dana 44 with flanged one-piece axle shafts. You cannot compare the CJ axle to the Wagoneer axle. For those...
Plasticine clay works well for measuring clearances. Put the clay in the joint and put it together, take it apart and check the thickness. Used by...
For a F134 Jeep, I would not be too concerned that my tires were not tall enough. Your gearing is not the limiting factor - instead you are...
Separate names with a comma.