Thanks for the replies.
I have a 1974 CJ with a 4.2 The parts book shows ( 5.123-2) [ATTACH] [ATTACH] part# 317 8359 washers on the clutch fork pins that hold the...
I don't really remember... I do remember: First we used muriatic acid to wash /etch the cement. Then we mixed the paint and hardener, had a...
My coating has been on the floor 20 years. The only problem has been where my wife spins the tires trying to get the car over a hump at the garage...
I don't know how the far the release is supposed to extend from the dash. But it looks like there is enough room to straighten out the cable by...
With your fingernail you can barely feel the groove in the shaft. I had problems trying to remove the input shaft. So I lightly sanded the groove...
I never thought about that. How would it work?
My front seal leaks. There is a groove around the circumference of the shaft where the seal is positioned. I had looked into installing a speedi...
I used a light grey two part urethane epoxy years ago. It has held up well.
I know this is not the same topic. What did you do for brake lines? Did you make your own or replace with original parts? The wiring , brake lines...
This is a big help. Thank you I noticed in the 6th picture, a terminal board mounted to the upper rail of the crossmember at the front of the gas...
When I have the rear gas tank flange just above the lower rail of the frame, I measured 3" instead of the 2" your drawing has for the back flange...
[ATTACH] Looks similar to my frame. 1974 CJ6
What are the buttons and pull levers on the bottom left of the picture?
My thought is they are positioned on the outside of the frame. You should really ask your questions to the seller .
I found some shims. Figured out they are for the trans crossmember. I also have to flip the crossmember 180*.
This looks great. Nice and very clean assembly. Currently I have no clue on how wires, brake lines and fuel lines are run. This will be a great...
Thank you. Now I can fabricate rear brackets, level the gas tank and fabricate the front bracket.
I don't have the body on my frame. Therefore I do not have a reference for how high the gas tank sits above the frame. I have seen pictures...
The Simpson 260 is great to check resistance of a contact closure. You can always zero the ohms reading or the needle. I used to carry mine in the...
Separate names with a comma.