Your first guess is probably correct :oops:
I've replaced them, just pop the old ones out out, stick in the new ones (right way up is a BIG help) & stake a few spots in the pump body around...
Last time I checked a 12 volt starter on a F4 draws ~ 130 amps wile cranking a cold engine. The question is how long can you keep cranking if it...
Find the casting number on the pump body & then call these guys- https://www.then-now-auto.com/
What engine?
Uless the engine has been sitting a LONG time I don't worry about it, there will be a film left on the bearing surfaces & there's no hard load on...
So it's a Battle to the Finish- the chosen weapon is Metal Reinforced Body Fill. First a couple of coats of POR applied under the right...
Update *NOW WITH MULTIMEDIA!* Last weekend I continued on with the sides doing a little final tweaking and starting the body fill to cover up the...
Spen trailers came with hup caps.
You're Welcome :) be aware there was an updated drawing in another thread sometime later, as well as versions for different years. You can find...
FYI I made new rollers for my ramsey, the old ones were a bit battle worn. [ATTACH] [ATTACH] [ATTACH] Note that the verticals are on shafts...
Ramsey sells one for their industrial winch series, i.e. hydraulic or electric versions of thier PTO winches. $$$ :(...
The part number for the F4 shroud is 806822, available on the aftermarket. This may be to closest to you-...
No it's a legitimate jeep wheel, made by, IIRC "Wheel Company", used for a bit somewheres during the CJ2 production run. That's factory paint on them.
These help? [ATTACH] [ATTACH]
You're Welcome :)
10 spline until mid '57 I believe.
I Object on the grounds of hearsay. :p
After doing a lot of research into this I run 3/8" 7x19 galvanized steel, & at that the rope place didn't like selling it to me because it's not...
No more jumping :schooled:
Separate names with a comma.