I'm trying to decipher the dimensions for the passenger side door opening used on the m170 Could someone check my numbers I guessed based on a...
Obviously abused but what do you expect when it's a one ton 4x4 fummins with a mullet. :bash:...
I could use a few drawings and details for the passenger side door opening on the M170. I don't know if these are in some military documents or if...
I'm looking for two or maybe more 16" wheels that match in width and weight. This is what I've got for the other two. [IMG]20210220_163054 by Joe...
We have had our 2013 Ford Flex since 2016 and bought it with 113,000 miles. Now it's past 151,000 miles and all of a sudden it has lost power to...
This is another 3D Printer project but it will take a lot of time and a little research. I've had this mess on my floorboards for about a decade...
May I have the center to center dimensions from the dash to the center of the forward sockets and from the forward sockets to the center of the...
I need the internal thread type and a good picture of the lettering for the 4way red knob. The one we all know and loose. The rest I can measure....
Someone hold me to this.:contract: I've talked about it long enough. Monday I'm calling. Taking the jump. Begging for a discount. Plan is to go...
Since I signed for it I might as well be proud of it... Replacing the "little blue car" Complementing the "grey car" Likely to tow several "blue...
What is the most frugal way to get the right amount of fuel in a Chevy? I'm darn tired of messing with rods and jets. I have a non vortec 4.3...
Where should I start to inspect for damage on a 19 spline dana 44? My 1960 seems to have a tight rear end. I suspect backing over some snowplow...
Can anyone get origional dimensions of where the holes would be for a rear seat? I'm using a fold and tumble intermediate seat and it's hitting...
I'm gonna try my best to recite this story... Fall 2007 a family in Missouri is moving there daughter into the college dorms. They walk past a...
Can anyone tell what i am making? I think it's gonna be cool! [img] But my wife just got home so I'll get it wrapped up tomorrow.
I finally got around to replacing a bad u-joint on my front driveshaft but the new u-joint doesn't fit. It seems my driveshaft yoke hole diameters...
Thank you Brian P for rebuilding my YF in 2009 and getting me back to my future wife. I really hope this can be added to the technical index....
Correct me if I'm wrong... if your jeep has an Overdrive. you want to stay shifted in direct drive when towing a trailer and or offroad and or...
[IMG]20191008_191757 by Joe with a jeep, on Flickr I picked this lil guy off the road with my tow bar. The bolt is definitely mine. These things...
I have a stock roll bar from a later CJ5 with the tube that is parallel to the early windshield and springs under the tub. I would like to upgrade...
Separate names with a comma.