The spring goes under the pin and is held in place by the tension between the pedal and floor. That said, with my particular set up (v6 with...
I’d probably go windshield down, but windshield up should be fine too as long as the latches are good. Another option would be to remove the...
quadratec 5 layer cover is really nice quality. It’s made for a tj, so a bit long for a cj5, but it will work....
Both the CJ and MGB have manual chokes. My normal starting procedure is to simply pull the choke all the way out (which does require briefly and...
I may be totally overthinking this… I know people talk about priming the oil on new engines builds before the first start up, but what about an...
I’m going to take a look at it today. Any sofa experts that can give me some advice on what to look out for?
All three of my winches have 9” drums and came with fairleads that are about 7.5” wide. So I would think a 14” drum with a 12” fairlead is just...
Depends a lot on the tire rating and the weight of the rig. On the road, I run 26psi in my JK, 22 in my tj and 15 in my CJ. Off-road they’re all...
I think you’re correct. But by using a snatch block when appropriate and keeping your cable in good condition, you can minimize the chance of it...
I’ve had more “sniff sniff… what’s on fire? Oh, it’s me!” moments than I can count.
I’ve seen 1/4 spacers at my FLAPS, and they’re available on Amazon as well, but they just float between the hub and wheel and seem a bit sketchy...
It’s like the mullet of the Jeep world.
Looks like it is real… https://www.hemmings.com/stories/2022/04/13/1983-vam-j3m-jeep-commando-mexico-find-of-the-day/amp
What type of tires and tire pressure are you running? I’ve found that even 5psi can greatly affect ride quality, as can a tire with a high load...
I was going to plug those holes, but then I got lazy and ordered a 1/4” thick gasket with the hopes it would block the holes off and not get...
[ATTACH] [ATTACH]
The Jerry can holder looks similar to what’s on my Jeep. A threaded rod goes into the hole on top, and then an angled clamp slips over the rod,...
i have a friend with a tilt up garage door. Someone kept trying to open it in the middle of the night, so he rigged the handle with one of those....
Is this an existing issue - like you already had something stolen - or just a “what if” scenario you thought up due to the ease of removing these...
Sounds like you have a relatively significant vac leak at either the throttle shaft or metering block, or both. If you had no leak or even a...
Separate names with a comma.