On My 1974 cj5 they were all the same.
That's A great picture , Love the Dogs.
HI jeff The turn signal switch is A Hudson Switch . They were made in 3 wire and 6 wire connection. The six wire was preferred . I have...
looks like he did a lot of cutting on the fire wall , other wise I like it.
These were A Jeep engine in Australia in the 1960's used in CJ 5's by Jeep.
Have You looked at Brennan's Garage web site He has A Power Steering Pump Bracket for The V-6 Engine , He also talks about different Pumps and...
Has anyone used Conventional Driven Motor Oil with Zinc ? If So what do You Thank Of it? What Weight do You use ?
I like the Blue paint . Looks really Good .
I have used heim joints for all kinds of linkages and they work great . They work best when used to push rather than pull.
Thanks for posting .
The Bearing in the picture looks like A thin shell Torrington needle bearing. should be able to get those at A bearing house.
Always used the b series rochester off of late 1950 chevrolet with manual choke. You have to get the right bolt pattern I thank there are two...
Do You have residual valves in Your Master cylinder or in the brake lines. Drum brake require 10 psi residual valves .
I have A 1974 jeep cj5 with 2-1/2" lift. I had to have Tom Woods Build A CV Drive Shaft . And Tilt The Pinion Up , reweld the spring perches ....
All Jeeps are A money PIT !
I always wanted one of those .
Always like Your Pictures , Thanks for Posting.
Great Pictures , Thanks for Posting.
Try Midwest Military Inc. 16075 Highway 13 South ,Prior Lake MN. 55372 Phone 952-440-8778 talk to John Bizal
I would replace the king pin bearing cap bolts with studs also.
Separate names with a comma.