Interested depending on shipping cost to 96003
:drool;:drool;
If you buy it and can get it to redding I'll store it for you till able to arrange shipping. Miranda is inland a bit so it may not be to rusty if...
It is a common axle but the way I'm understanding it these are for 3.73 and down gears and most of us run 3.73 and up I would buy one but it...
If you end up using a speedy sleeve the seal will say on the box what size to buy or have a part # for it.
No harm to the case if you use oven cleaner. Personally I prefer solvent in a solvent tank .
Seal removal tip. Use a sheet metal screw a couple inches long. I like to use a self tapping one. screw it through the seal and grab it with a...
I have a stock rear seat and all mounting brackets for sale or trade. Removed from a 1975 cj 5 tan in color needs recovered Levi edition with...
We need pictures of the jewel in the background.
It could be I welded the hole shut on the in side because I'm not going to use a cable. No gears left in it I'll look in to it
Yep it's a Jeep just like a dog marking it's turf. Rear out put on transfer case is leaking past the seal already and it's not even close to...
Jim there is a new add from windchill that says he has a set of KH wheels for sale its listed as a cj 6 and parts
Got the transmission and transfer case and cross member with new mounts got some of the brake lines roughed in lots of little thing go in to...
Ok
[ATTACH] [ATTACH]
Yep that’s what I have I’ll get you a picture as soon as I can
Through the floor pedal arm is what you are looking for I have one I'll post a picture when I get home
Good job trouble shooting and solving the problem. It’s good motivation to finish the project hearing it run.
You would have spark even if the vats was still enabled all it does is shut off the fuel.
Bad ign. Module? I know this is a conversion but is the check engine light illuminating when you turn key switch on it must to make spark if not...
Separate names with a comma.