I don't mind a spool in the rear but the downside is the rear pushes the front around on soft terrain like mud.... most noticeable on tight turns....
My 3b had the fenders welded to the grill and the grill mounts.
It was good to meet you and see your Jeep project.
In case you didn't see the pm I'm in Clinton for the weekend. About an hour from forest.
Biloxi is a short trip from your place. Grab the D44 while you're at it. EEBrakes and all still attached to it. If you need an sm465 I have one of...
If you plan to add Saginaw steering I have a 4 bolt gear at the house.
I lost interest in this for awhile but I got the front end done and working on the rear. I had to put a transmission in the jk and rebuild the 241...
You could try this seal. Fel Pro SS70037
I tried to get him to build a 429 or 460 but he just had to have the 400. Imo, a big block would've been better money spent.
400M I'm building for a guy. It's going in a 79 F250 and the guy plans to drive it to his wedding in 6(?) weeks. I did all the machine work and...
Some of the puzzle.....
I'd rather have an sm420 but this junk was in the garage already. Still might get an sm420 if I can find one...
It's a Volvo desert here! I found a couple of candidates but I don't want to pay $1k for an engine and wiring harness.
I had a slew of engine swap thoughts but most were just that, thoughts.
big block GM/Mopar/Ford
Had one but it's my brother's now. It's a stout engine for its size.
A 2.8 bellhousing would fit the bill and bolt to an sm420/sm465 but I'd have to source a flywheel, clutch kit, etc. The bellhousing is not that...
Boat anchor :D :ninja:
The L67 is a supercharged Buick 3800.
4.3- common sense swap choice but no supercharger.
3.5 EcoBoost- heck no
VW TDI- $$ & major fabrication...
I have a rebuilt 5.3 but it just makes too much sense to swap in something common and I want this 3b to be somewhat different from...
Right. 60 degree to 90 degree. No biggie
Separate names with a comma.