This was spotted on ewillys.
Ordered from Speedway motors in the past. I Cut and threaded DOM tubing to my specific needs
[ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] [ATTACH] Vintage reading from...
Did you try Pete Debella? He had some nos a while back
Might check the accelerator pump. ?????
Didn’t these have the Chevy 153 with power glide ??
This is for the early offset. #25 I believe is the axle seal. “Radial seal”
I have two Warn kits that I installed on early Cj’s with offset axles. Both have the locking set screw on the hubs.
One was brand new, the...
Are all your tre’s correct for that application?
Mine were grooved and military wrap front and rear.
Not sure if any of this matters, but here are the numbers that were on the springs of the 56 cj6 [ATTACH][ATTACH][ATTACH][ATTACH]
My 64 Cj5 are grooved but not military wrapped. I believe them to be original to the jeep.
Question, were not the m38a1 “reverse” also and...
The left image of a 56 cj6 with front spring “reverse” shackle. Note that the pivot point is in the frame.
The right image, 64...
Do NOT do a web search for a web site. The old R&P website has been corrupted and Richard cannot do anything about it.
Check out “metalshapers” t90 rebuild on YouTube
He uses a “sealed bearing” ( inside seal removed) to prevent this from happening. I believe...
Separate names with a comma.