I think there could be a bit of interest on OWF....so I linked the add to them.
I used these guys in Denver - I was local at the time so didn't have to deal with shipping, but I would certainly consider shipping to them if I...
Yup...not a D18....most likely a D20 I retitled the thread for D20 and moved to the intermediate cj classified.... thanks
So I did some test fitting of the empty case and found the holes line up a bit easier in a specific orientation..... reassembled and tightening...
Just to help clarify....if the transfercase was original to the 75cj5, it would have been a D20 unit. I would expect any buyer would like to know...
Isn't the posi unit for the 4.88s the same as for the 4.27s?
Hmmm....so is it running?
Jim....do you have any D18 parking brake parts to go with the D18 output cap? I guess the most important piece would be the backing plate? Thanks!
those are the ones I use....every so often its worth disassembling the unit and adding a just a bit of silicon lubricant to the rubber plug that...
Have an issue....I broke a small tab on the ring gear side of the case when tightening the two case halves together....how much did I eff it up?...
Anyone have some D27 set-up bearings they wouldn't mind loaning out? I am happy to pay shipping and return etc....figured I'd check here before...
Had a little time to mess with this....I decided to spend a bit of time figuring out how everything fits together and what is the best way to...
I managed a decent fuel resistant epoxy repair for the support arms for the central female threaded air cleaner support post. I figured it...
Don't see a lot of these....in CJs, 30spline is usually the inferior trac-lok https://m.facebook.com/marketplace/item/969197304212892/
Here is what the 71-75 skid looks like http://www.earlycj5.com/xf_cj5/index.php?threads/111065/page-2#post-1234546
On the 71-75, the tank bolts to the frame and the skid bolts separately to the frame. This is the set up I used as a retrofit into my ecj5 - got...
Trying to track down new clutch discs and plates to rebuild this D27 PL. I was able to get replacement pieces for all of the plates, but only the...
Hi all, Nick has been helping me get some parts to rebuild a D27 powerlock, but I am still in need of 2 of the 'curved' Belleville clutch disks....
Yes...32" ididit will work fine
There's your problem right there....
Separate names with a comma.