Possibly something to do with the engine being pulled? Drain the coolant and oil and leave in those containers for recycling?
I was thinking the same thing. If I can drive in an S pattern, I clearly don’t need my lockers engaged.
One thing I forgot to mention is that I did do a little trimming to get the stock sheet metal to line up with the metalcloak rear fenders (see...
rear does have the slightest rub when stuffed, but it hasn’t even rubbed thru the paint so I didn’t bother to fix it.
I put an OME 2” lift on my 2001 Sahara. Metalcloak fenders gave me clearance for 35’s. Also installed metalcloak control arms and a Currie...
Remember the old adage: spoke on top, please flipflop! Don’t be a clown, keep the spoke pointed down! [ATTACH] Actually I just made that up,...
I’ll preface by saying I’m a self taught welder. I have two machines, a 110 harbor freight and a 220 Hobart, both running flux core. If I were...
I’ve since upgraded to 11” brakes which use flexible hose instead of the hard S lines. But if I remember correctly with the 9” brakes, I started...
If you re switching from a 31” tire to a 33”, you’re only losing 1” of clearance between the tire and fender. To get that 1” of clearance back,...
I rewired my 56 Jeep with a bluesea 12 circuit panel. My Jeep is extremely basic. Probably could have gotten away with a 4 circuit panel, but...
I’d probably start with a wire hand brush and some elbow grease. If that fails, they sell felt flapper discs for angle grinders which should be...
That’s crazy long. When the kids say “are we there yet?” You could reply, “well I am, but you’ve still got a few hours.”
They’re kirkey vintage class bucket seats. Mine are the 17” model. https://www.kirkeyracing.com/category/S55V/55V-Series-Vintage-Class-Bucket...
Does Manuel help put this together and do I have to tip him? [ATTACH]
Very cool. So who will sue them first, Jeep or mahindra/Roxor?
I have speedway “military” tires on mine. They’re 8 ply and labeled as 7.50-16, but seem to be closer to a 7.00-16. I wish they were a bit...
I’d have someone else sit in the driver seat and operate the throttle while I watch for oil leaks/spray. I don’t have any experience with the...
I’m not tall, but I have a long torso. The seats installed by the prior owner had me literally looking over the top of the windshield. I made...
I agree with using a penetrating oil. Another thing that may help is removing the cable from the Jeep and holding it vertically so the oil can...
On my seat frame, the passenger side and rear of the frame have three holes. So the bolt remains in a fixed position on the floor of the Jeep,...
Separate names with a comma.