I broke a flanged 44 at the splines, It also took out my carrier. I was running 35's and got a wheel in a under cut. I went to superior shafts...
i totaly agree it just makes me sad. :(
I am in the process of taking my 71 cj5 from a cut up jeep to a full tube buggy. I finaly got around to the painful part of buying a dana 60 front...
[IMG][/url][/IMG]
I'm having trouble with the pic any words of wisdom?
That is a very clean install. I might have to work that in on the tube chassis I am starting. Very nice. Scott
If your looking to get a better stance for the trail I say go for it. The dana 44 and the 10 bolt theres no difference in strength. I know you guy...
Now that I saw the pic of the drum I was wrong thanks for the correction.
The pumpkin looks like the offset 44 the drums look quite a bit different than mine do. Do you have a picture of the drum or with the drum off and...
GDI got me a nice replacement that bolted right up with no problem. It also ran 15 degrees cooler after.
If I'm not mistaken and this is a offset flanged D44 it should have a seal at the end of the axle tube. There is no seal on the backing plate it...
Thanks for the help had a bad oil pump after me rebuild and seems to run ok with the new one thanks. Scott
I seen one like this befor on early 2 1/2 ton But the back cover on this on looks different.
71 Cj-5 my money pit :D[IMG] [IMG] [IMG] [IMG] [IMG] [IMG]
This is one I boat sided and ran 35's. [IMG] [IMG]
I had the same problem. I welded another shock mount behind the axle. Just be careful if you move the top mount to far back and copress the...
I don't have any pics right now do to computer problems but I will try to post some for you. I had a warn black diamond 3" lift with stock shackle...
The first jeep I owned had that swap done but it still ran the Dana 18 t-case. The drive shaft look like it wouldn't work but, I drove it as a...
Does any one now what the oil pressure range should be on my Dauntless v6.
Separate names with a comma.