here is what I found a month ago, been waiting 4 years for them. came out of a commando. I forget the year but they are the same as the ones I...
here is an Oct69 built 1970 CJ5 plate. [IMG]
what year is the body, that will help you get the right one.
this is pure speculation: Could this be a factory frame from from one of the backhoe jeeps, Go For Digger? They came with tandem axle on the...
the tie down for the windshield is to the left of the mirror and bracket. mirror is in the correct place, based on my 70CJ5.
Just to make sure you know what you are getting into. The front seat brackets in the commando are really different than the brackets in the CJ5....
perfect fit. [IMG]
I had the chance to get some seats from a commando and they are really nice and they fit. On the bottom of the frames there are 2 sets of mounting...
What nickmil said. Also I believe that the single stick was used in all 225 V6 applications with the T14A transmission. My Oct69 1970 CJ5 has...
Willys would build anything you want. I have touched this. It lived in Wyoming 10 years ago and I got to crawl all over it. It could have been...
in my 1970 CJ5 the twin sticks did not fit in the hole as you describe with out making it longer to the passenger side by an inch or two. I had to...
Here is the main floor pan for my 70 CJ5. the large rectangle cut out is for the transmission. The small notch on the right is for the OD shifter....
NOS stuff. http://www.debellajeepparts.com/oddlot.htm
try this place http://www.debellajeepparts.com/oddlot.htm
here is a good link with pictures information and a rebuild job I did that I am not happy with....
The other side of the linkage can be seen in this thread. http://www.earlycj5.net/forums/showthread.php?101530-225-engine-assembly/page4 grannyscj...
mine has a pedal that mounts to the floor cover plate, and the linkage slides up and down in a groove. It appears that yours did too. Check the...
add 1970 CJ5 V6 to the list.
gas tanks went from under the seat in early 1970s CJ5s, sSept to Decenber 1969, to the back after AMC took over in Feb of 1970. Other subtle...
The T14 has a spacer on the outside of the rear bearing, between the bearing and the bull gear or OD bowl gear. see the install video here....
Separate names with a comma.