I'm trying to set up hei, on my 225. I've been reading allot of articles and posts on here and other forms. One thing, I can't seem to get a clear...
Looking to remove my tub, but I can't figure out the removal of my steering system. This jeep was built by the previous owner so I am not certain...
Went to fire it up back in April, came across a rusty gas tank, decided poly was the right replacement, also this shot shows the new floor pans...
Did a little more investigation, it will start when trying to bypass the switch and I believe it will stay running without the start wire, I am...
I have a CJ3A that has a dauntless motor swapped, in regards to the actual wiring of the ignition I thought this might be the best location to...
It was a long winter, not working on the Jeep, finally got some garage time this afternoon and got a lot of progress in putting this back...
Here are few more, figured I would make both floor supports at the same time. [IMG] [IMG] Here is that wiring kit some what installed [IMG]
Got what seems like a lot of progress done over the last month, without working any weekends and now its starting to get cold. I started off going...
Did a little work early this morning, I had some time away from the jeep so not much has gotten done. I ordered parts for the passenger side I...
I am planning on only doing one side at a time, both due to space and complexity. Th driver side is better in this location, but worse under the...
Got some work done this weekend. Cutting out the old and sizing up for how much repair I need to do. Removed the Tool Box [IMG] [IMG] Found...
Found these on a different forum...I might try to duplicate it. [IMG] [IMG]
Has anyone used angle iron in replacement of rectangle tubing?
Got some time over the last couple of days to do a little work here and there. Pulled off the rest of the paint and started to mark out for...
I'm leaning towards one of these two methods, probably the second one.
Sorry for the delay in from the other week for who ever is following it. I got tied up prepping the XJ for a trip to the Iron Range [IMG] Back...
Started ripping into this over the weekend. I ground off the bondo and body filler on the passanger side- roughly 1/2" thick at the bottom of the...
Good advice, that is one of the main reasons I got this one...the body work is enough to keep me busy, but to keep it running. I do plan on...
Good to know. I'd like to be tall and skinny, so I might end up trading the ones for a little bit narrower...in time
One of my first mods will be to add belts... I do have some what of a cage...but I believe it is important to have them.
Separate names with a comma.