I vaguely remember someone on here talking about a possible catastrophic result from leaving out the "pill" which goes between the shift rails but...
It's been a couple of years since I converted mine, so some details are kinda fuzzy. I do remember reading in the instructions about orienting the...
Thanks for the info, but I have already been down that trail with the output shaft. This time it is the intermediate shaft that is leaking.
I hope that this question hasn't been asked a million time on here and my searching skills are just pathetic, but I didn't see this particular...
Congrats, I hope that you are half as happy with yours as I am with mine. I had a similar problem when I first started it up too, it seemed that I...
Thanks to all for all the good information and prompt feedback. This was part of my concern, I couldn't exactly put my finger on it but I got kind...
Is there a way to verify the VIN of a flattie if the VIN tag is missing? Should I give up and keep looking? Background: I have been looking...
Don't forget to look at the other side of the circuit also. Once I had a similar problem and found that a PO had used steel washers to shim the...
In regard to the wire that you were talking about, check out this thread. Toward the end of the first page Phillip-TX includes some excellent...
Another option, Kaiser-Willys sells two different stock height spring packages for the front end one is the heavier duty 10 leaf pack for use with...
When I started messing with my '68 which has at least a similar set up to yours this is exactly what I found. The brittle old cowl gasket would...
Just my opinion, but I think that you will be much happier if you ever have to go back in if you just clean both surfaces completely, and make...
I'm sure that you probably already thought of this and verified, but I'll say it anyway. Are you sure that your vacuum advance is connected to...
After I got mine painted, I used my cherry picker and a few nylon straps to get it back on by myself. Only minor touch up required.
Were you thinking of McRuff? I think that Nick is somewhere in the Northwest.
When I replaced my 7 packs with the heavier duty 10 packs, I found that the same u-bolts accommodated both spring packs. If you still need...
As you have heard already, the best place to start is to get underneath and inspect everything. But, if you have a Ross box it will more than...
I remember a thread a few days/weeks ago that was eerily familiar to this one. I believe that the final solution was found when someone (Timgr?)...
That does look like the remains of a back-up light switch. It's in basically the same place as the one on my T-14 is.
When I did mine, I found that an angle grinder worked best.
Separate names with a comma.