The last time I drove my Jeep, I noticed the front driver's side brake drum grabbing and it was progressively getting worse as the day went on. I...
Bought a new MIG welder. I went with the Hobart 140 based on on-line reviews. I'm going to practice with flux welding before stepping up to gas....
I've posted this before but I have a little more information. I have a stock '59 F-head with T90 tranny. Clutch, throwout bearing, pressure...
Took the JEEP out for a spin today, drove for several miles. When I pulled in the driveway, I noticed a stream of oil leaks behind me. Turns...
A while back, after I finished my restoration, I posted the question about my engine cutting out at high speeds. I will be cruising down the road...
I have an odd vibration and grinding noise coming from the vicinity of the transmission. Intermittent, only seems to happen after I've been...
I have a '59 CJ5 with original F-head motor. Once upon a time ago, I posted here that the engine would cut out at cruising speed. Once I am in...
I bought a half cab from a fellow forum member. Not sure of the brand but it is complete with hinges and doors with crank windows. It needs...
'59 CJ5 original F head. This has happened a few times now, though it seems to be random and doesn't happen all the time. When travelling at...
As I was putting my F head back together, I installed the new oil pump and clocked the distributor so the #1 cylinder TDC points at 5 o'clock on...
Last time I assembled my engine, I used standard grade 8 bolts for the head. However, I had read that grade 8s (especially those made today) may...
This was the passenger seat that came in my CJ5 but I know it is for either an M38A1 or a flat fender. Anyone know? [IMG]
In trying to remove the oil galley pipe plugs from the outside of the engine block, I ran into a major problem. The one with the hole in it that...
Section E-40 of the FSM explains how to check the "crankshaft alignment." I followed the directions but I'm not exactly sure what it is proving...
Looks like Walcks and Kaiser Willys only carry Omix-ada oil pumps. Omix stuff worries me but I figure reputable vendors wouldn't sell them if...
I know I have been a man of many questions lately but I have another one. I removed the four corner head bolts in order to pull my engine. Can I...
After successfully putting 150 miles on the Jeep after the rebuild, I decided to get brave and stray farther from the house. I took it for a long...
I need help identifying a hideous growling noise that I believe is the transfer case but I would like some second opinions. I'll do my best to...
The oil bath air cleaner on my '59 (original to the Jeep as far as I know) is leaking oil when I drive. It is either leaking from the where the...
Just finished my 2 year restoration on my '59 (well, not quite finished but roadworthy anyway.) Took it down the road for several miles and have...
Separate names with a comma.