Stripped my small hole d18 and 20 to put the 18 gears in the 20 case, and both have the 1.25" intermediate shafts I thought 55 would have 1 1/8?...
I don't even know how, but my 71 t case is cracked across the top of the two nubs on the rear for the shift rails....not quite 2" long....doubt it...
found another parts jeep and was wondering how much of a PITA it'd be to pull off the shifter and use on my plain Jane cj....thanks!!
Swapping in another power train from a 70 into my 55 and the parking brake is full of oily gunk...anyway read about using two thinner seals in...
Tried searching but couldn't hit the right phrasing I guess, sure it's been covered plenty But new springs for my 55, with rubber bushings...
Just picked up an abandoned project....1970 cj, dauntless V6, new 2.5 lift, shackles, and new brakes with SS brake lines Those alone are worth...
Can't seem to find if a 55 had the dash mounted or between the seats on the floor style parking brake lever....any ideas ? Thanks a bunch!!
Just flipped my tub up onto the fire wall to do some more repair work and was going to tape up my speedo to protect it from...
Opinions please!!!!! 96 ford ranger 2.3 into 55 cj5... Bought an alleged pinto bellhousing, on right....88 t-bird on left.... Also pinto to t90...
Got a 96 EFI 2.3, pinto bell housing, flat adapter, and a 55 cj 5..... Now I'm unsure of what throw out bearing, release arm, and crank bushing...
Mine were mangled and cut off and discarded awhile back, but would like to get height, wdth, and also the length of the back cuts in the front...
Mine came to me with the grommet style lights on a big rig trailer that sit flush, not the original tail lights...anyway, even after looking at a...
Just too cute to spray bomb or camo the whole thing over and make it look pretty, so I need to paint over some repair panels. Anyone know what...
Double post sorry!!
I have a T-bird bell that is I think a 1/2 deeper than the elusive pinto bell, and have some thick plates of steel, with which to simply drill...
That trim piece on a CJ5, that's under the tailgate frame, that's cut out to go over where a pintle hook could bolt on to the triangulated...
Long story short, my rear of the tub was rotted around the tailgate opening and the seams by the tail-lights, so I stole Posi's idea and made a...
I have not one clue about seam sealers, really, but I am going to ***-u-me that I would want them over any welds that aren't covered with bondo...
I hope this is the best place for this.....anywho.... I am trying to find a set of the bolts that hold the two halves together for the split...
They filed chapter 18 or 13 or some damn thing, so all their 1" kits are out of stock, or on back order indefinately at the few places I tried to...
Separate names with a comma.