Yup, Hemlocks, Red Maples, Poplars, Pines and White Birch took the brunt. It was a nasty one....you stay safe too...
It may be a while before another post. We've had a pretty major storm late last week and I'm finding myself in a situation where I have somewhere...
Piss coat of OD....Oil tube installed [IMG] Water pump..... [IMG] Wiped down with acetone, just a quick and dirty coat.... [IMG] [IMG] Still...
Carb is all set....Rebuilt by blalp! YS 950 [IMG] YS is all set, thank you Shaun.... [IMG] [IMG]
Engine work today. New Victor head gasket. [IMG] And brand new head bolts. I didn't trust the used ones. They were pitted. [IMG] Shaun came over...
I'll explain the reason I'm going with Beachwood (without overly justifying). They offer 3" covers and cushions rather than the standard 5". I'm...
Yes, I bagged about a ten days worth of work for the guys. I was proactively checking on a number of our regular accounts. Most of it in...
OK, I came home from work and so happy to see that our power has been restored!
August it is Jonathan. I'll try to remember to ping you!
If you're around for a visit, I'm around. Would be great to meet up...
We're good!
Didn't venture into work today. Clobbered with snow which began late yesterday. 10" so far and still snowing moderately. Power went out about 7:00...
Chances are that the transmission problem is being caused by some rust under the shift cover. It doesn't take much condensation over the years to...
I won't be back cutting. I'm keeping things simple here folks.....I'm confident that I have a better than factory mating surface, or I hope,
You mean grind the valves? If so, I did not. No need to I believe.....
Greetings easter eggers (eggheads). We're home so I was able to get some things done in the shop. I wasn't satisfied that the valve seats were...
Driving the new valve guides.... [IMG] One inch below the deck. Not exactly a precision measurement, but considering that the old valve guides...
Success. All four are out and I'm getting the chamber cleaned up. Pete, that was a good pro tip and I'll do it the same way next time. [IMG]...
OK, plasma time. I've driven down the exhaust valve guides to just above the tappets. They are too long to drive down further, PeteL suggested...
I was eyeballing that as well....
Separate names with a comma.