If it does not cause stalling without it, the throttle would be a lot more the way I want it without it. I would like it a lot more with a cable...
Terminology screw up. It is not a bellcrank, it is an arm. Thanks for the replies
This is my first experience with a dampener on the the throttle bell-crank. When you release the throttle, it slowly returns to idle. What is...
WOW that is a big chunk out of the cross member. Was anyone dropped or raised the box enough to clear it?
Unless I was racing my jeep, bwwa ha ha ha, I would not consider a single plane. Are you talking about the split plane offy vs the dual plane...
This is related to another thread I had going but different enough to justify a new one. Before I reinvent the wheel and or do something not...
Good point, thank you. I will check what my caster is before I take my front springs apart. Where ever the pinion ends up, is where it goes.
I have set up a few RWD pinion angles before. But, the one on the front of my CJ seems wrong to me. The front yoke is facing up. To be parallel...
Check to be sure the rod cap and the cylinder next to it are not on backwards.
Does the adapter need a 4 5/8 center hole? Just my luck, I got the only "generic SBC Bell" that isn't. It's off a 1963 Corvette and it has a 4-1/8.
Does it have a D18 transfer case LOL.
This If you are unsure of your abilities, just extend the plates a little longer and don't weld across the frame. I like to weld them all the...
Now you are getting into an area I will not claim to have extensive knowledge. 6011 runs hot at will probably promote cracking without passes of...
The 6011 is a great rod if you want to be lazy and not properly clean the surface first. Then, go over it with a 7018. The 6011 is a way more...
I finally got around to this part of my project. I removed the oil filter and blew air into the oil ports under the rocker assemblies. I got a...
[IMG] Thanks guys. I quick test fit of the tire reveals the plastic fender extension has to go. I am scared of the world of hurt that is...
Wooden support?? Do you mean the dampener I do not have?
I have no holes. This piece of rusting iron is a quilt of patches. The mount was in a box given to me by the PO.
[IMG] [IMG] Is this the correct one for a 1970 CJ5? What is up with the yellow lens? Is a red one available some where? I have not measured it...
Did you try using ported vacume? That would be the equivalent of plugging it when off the throttle. I hate to sound redundant, but do you have...
Separate names with a comma.