Guy's I've searched the forums and don't see an answer to my question which is: Is there a suitable distributor cap that fits the stock...
Replaced all four springs with Omix stock type springs. The installation was typical for a Jeep mechanics, a lot of unexpected little things but...
My new set of Omix stock type springs all have open rebound clips. Shouldn't these be closed around the top of the spring? It looks like these...
I purchased a set of "stock" replacement Omix springs and replacement attachment hardware. The Omix u-bolts are stout 1/2 inch bolts and I found...
I just picked up a an older MSD 6A and wanted to use it with my stock (72) Delco distributor and points. The old cap, rotor may need to be...
I thought I could use my old hoses but found out yesterday that they are in pretty bad shape. I filled up and pumped gas up into the filler hose...
My 72 has a lot of body lean and rides really loose and soft. I noticed today that number of spring clips and their associated...
Yet another post regarding my exhaust leak. I figure it's best to post separate threads for ease of future searches. Yeah, I know I was warned...
My exhaust noise/leak now appears to be a manifold leak so I will be investigating and probably replacing the manifold gaskets. The last time I...
Installed the flange gasket today. It was a bit of a struggle getting clearance between the manifold and the pipe so I could insert the gasket but...
Which way does this install? I think the tapered end goes down into the exhaust pipe and the other side goes up into the manifold. The parts...
I'm getting my 72 back together and had to re time the engine because I messed with the distributor. The book says 3 degrees but in my studies of...
I'm cleaning up stuff behind the dash while I have the dash out and was checking out the heater and associated bits. I pulled the fresh air duct...
I'm going to be replacing the engine mounts on my 72 I6 and had a question about lifting the engine. Can the engine be jacked up from below? I was...
After a futile search for the lower steering column bearing for my 72 I've been on the lookout for a suitable item. Someone here suggested that I...
I'm about to reinstall my repaired and re-sendered gas tank and had a question about the pad. Does anyone use this? If so where can I get one...
Now that I have my gas tank out I'm going to replace the bolts and bushings on my rear springs. Anything I need to know before I do this?...
I've pulled my gas tank (great fun) and skid plate on my 72 and have a question about the skid plate. Mine has a bend in it that looks pretty...
Well, finally got up the nerve to get the Yokohama's. Discount Tire called me today and I got them installed this morning. Everyone in the shop...
Has anyone considered/used seats from industrial equipment to replace their trashed seats? I know you can get a upholstery shop to recover them...
Separate names with a comma.