Temp that is. Driving to my friend's place last sunday morning and my Jeep coulnd't get to its normal operating temp - especially when I was...
I was wondering who was going to buy one. I don't have any info but I'm curious why you went that route?
Have one. Jeep loves it. Plug that bad boy in an hour before a wintery adventure without a problem. Like Todd says gets my in cab heater up to a...
Did a search and couldn't find an answer. Simple - what size could my lug nuts be? 1968, D27 and D44. And are wheel locks just over the top?...
Mike great heater. I've got the same one. Are you going to use the hoses to route the heat or are you just going to let it pour out like the...
No experience with the Tigertop, my Supertop on the otherhand has been great. My two issues are the damn door strikes - ripped two suit pockets...
I need to do mine before the snow gets here as well. Bill you go first then you can walk me through them.
My dash is littered with oil pressure, fuel, volt, water temp, tach, fuel pressure, and something else. The only two guages that actually concern...
Thanks so far. Let me get this straight. So I should move my temp sending unit to B and my inlet for my heater to A, according to my latest...
That's what I thought. And I was just looking at the Jeep manual and it says, "The heater inlet hose is connected to a port on the right...
I've hooked up my heater but it doesn't work the way I've got everything attatched. I was going to try and explain my current set up but pictures...
Just ordered it. I'll tell you in a week how it works.
Thanks guys any pics would be great. Mike I'm off to the junkyard tomorrow to get those Volvo spitters.
Moving to Pittsburgh soon, installed the in coolant block heater and waiting for my in cab heater but I realized how will I see without windshield...
Got my 8000 Series Tank/Circulation Style Engine Heater today and was planning on installing it into jeep some time this weekend. It looks like...
Which one the neoprene or the original rope? What's the difference?
Does anybody off hand know where I can get a rear main seal for the V6? Going to put a clutch (LUK) in this week so I may as well do the rear...
Turns out one of the screws that holds down the rotor inside the HEI had backed itself out and danced around inside a while. You can see in the...
What octane gas are you using?
I would think that would work with a little fabricating. Check out this place for small parts like latches, hinges, etc:...
Separate names with a comma.