Where did you get your rebuild kits, and how much were they? I need the gaskets and my LPS has no idea what I'm talking about. Thanks.
Thanks for the input. I see what I need now!
After reading this thread, I went on ebay and did some research. I found a pump from a '75 Buick 350 and one from a '80 Buick V6. The brackets are...
So what is the total cost for this setup? I would like to know how it does on the road!
My '71 was pieced together by the PO and I dont have anything on mine. It is going back together in two weeks, do I need something on the transfer...
Here is a good one with excellent pictures. http://www.willysjeepparts.com/index.htm
I guess I will look into the Powr-lok. I read some things about it and would like to know where to buy the unit? Does it fit the '71 D44? Thanks.
Thanks for the info!
I have 30 spline, Flanged axles. The same as the one I am looking at. I keep reading it will fit. Is there a good site to read about the differences?
Does anyone know if the Track Lock from a 2003 Wrangler Sport w/3.73 will fit the '71 D44 Track lock w/3.73? I need a new carrier w/spider gears,...
I think I will stick with what I have. I'll know more when I crack them open. Thanks!
I have yet to take the trans and t/c apart. They are out of the Jeep. The fluid had water in it and I do not want to take a chance on any...
Im looking at rebuilding my T14 trans and Model 18 t/c because of mocha trans fluid. My brother has a T150 trans and Model 20 t/c. Will it...
Are they radial or bias ply? I have had radial tires pull. Bias ply will pull if the treads are worn at an angle. Try rotating the tires.
Sometimes a little bit of dirt will clog air ways. Try reving the engine and then put a rag over the carb horn untill it just abouts dies then...
You should put the lifters in a shallow pan or can. Add oil just over the tops of the lifters. Then use a push rod to bleed off the air. Oil...
I bought new channels from JC Whitney. 16 gauge and bigger than stock around 11.00 each @ 3' long. Where the body mounts I am welding in a piece...
Separate names with a comma.