that's a cool shifter sticker. never seen one like it before.
looks kinda like the seats from my college roommate's early 80's VW Rabbit GTI.
I use a local alternator shop to rebuild mine and avoid using "rebuilds" as the cool flaps that dealt in quality parts closed a few years back....
one of my parts axles has nuts welded on the housing as a limiter.
I shift 1st, 2nd, 2nd OD, 3rd OD, rarely use straight 3rd unless I'm pulling a hill or in city traffic.
That's the coil I have, and it's mounted on the DRIVER'S side using a bolt on the intake manifold.
Two of the bolts on one of the knuckles (I "think" it's the right side) got helicoiled during the axle rebuild.
I would start with adjusting the retaining latches, followed by a new rubber weatherstrip, and lastly using a shim.
1966 has vacuum wipers (I 'believe" 67 does too), as I removed mine for an electric setup. I used the vacuum line grommet for the windshield...
My parts R1 is also purple with a white engine compartment. I'd get pictures, but the "security" hornets are currently in residence.
I used the Comp 260H, and the motor is kind gutless below 1500rpm, above that is another story.
I went from the single to the twin-stick when I rebuilt the D18 (added the OD, and went to the T14 at the same time) as I got tired of fighting...
It sounds like the cap isn't venting and causing a vacuum in the tank (hence the air bubble sound). Try loosening the cap slightly and see if it...
from what I remember of my t86 to t14 swap: I had to move everything back about 5/8" (cross-member/clutch linkage), lengthen front-drive...
If I had to redo this mod, I'd use all 1978 model year parts (tank, neck, hoses, skidplate, and mounting bracket) instead of the 1970 tank with a...
sounds like the syncros between 2nd/3rd are worn out.
did you soak the lifters in oil (to prime them) before installation?
1st generation bronco front brake backing plates (1966-75) are what i used (dana 30 can't use the rears as they used 9inch axles). did have to re...
if you had a jeepster or wagon, cool swap. early 5 not so much. would go :v6: or iron duke 4 banger. a poncho slant four could be an interesting...
run straight 30w in mine (per factory manual). ran 10w30 for a while, but had too low of oil pressure when it warmed up at idle (could hear the...
Separate names with a comma.