Tried to source a new one a few months ago, but couldn't find anything decent. How bad is yours?
UPDATE: I got the Jeep moving under its power today! Spent the last month doing the following: Resurfaced flywheel New starter ring gear New...
Cam plug on the back of the engine?
I had a similar situation years ago when the wiper would "invert" and hit the cowl. For me, it was a combination of worn/broken bushings and the...
I'd love to upgrade to a T18, but the goal at the moment is to get it back on the road. That's what I was thinking it's just the reverse gear all...
More progress! Got the flywheel machined, and picked up a new ring gear for the starter which has seen better days. [ATTACH] [ATTACH] Started...
2 u-joints (spicer 260 series) are used in the front axle at the knuckle and 4 (spicer 1310 series) are used on the driveshafts. No experience...
The Weber carbs don't like high fuel pressure, 2-4 PSI. Facet, Carter, and Mr Gasket make low-pressure fuel pumps. 15-20 gal/hr would suffice....
My 73 (nov 72 build date) has 3 knobs with a separate 2 speed toggle.
Thanks for the advice! I'm reasonably sure I replaced the pressure plate in 2003 along with the clutch disc and throw-out bearing. The clutch has...
That's the plan! No heat checking, I think it will be good after re-surfacing. I skipped it last time and that was a mistake.
I have an update. We had a warm day up here (34F) and I took the opportunity to pull the transmission, transfercase, and clutch. The clutch is...
I wonder if the older escape calipers will work for folks who want to keep a mechanical parking brake? [IMG]
hanks, everyone for the honest advice! Even if it's not what I want to hear! lol I'll pull the transmission and transfer case out sometime in the...
Drained the transmission fluid... it's in even worse condition with a little solid debris in the bottom of the case. I have a second car at the...
Yes, it is D20 all original around 100k miles.
Drained the fluid today in preparation for changing a front output shaft seal. Quite a bit of metal fuzz and flakes on the drain plug magnet....
My 73 brackets where not threaded but used a clip on nut. https://www.mcmaster.com/products/clip-nuts/
I had a similar failure. The original mount is cast steel of good quality with little porosity which leads it self to welding. l I had a friend...
It's blocking a good portion of the grill. A lifted V8 Jeep running fast up a grade with thin Colorado air is approaching the limits of the...
Separate names with a comma.